What We Fix
Premium dishwashers are prized for how quiet and thorough they are, and when one stops draining or leaves a leak on the floor it is usually a specific, fixable part rather than a lost cause. We repair units that will not drain, leave dishes wet, leak at the door or base, will not fill, or display an error code and stop mid-cycle. Panel-ready and integrated models behind custom cabinetry are well within our scope, and we protect the panel and hinges when a unit needs to come forward.
Common Problems We See
- Standing water at the end: a clogged filter, blocked drain hose, or failed drain pump.
- Dishes still wet: low rinse aid, a condensation-dry model opened too early, or a failed heating element.
- Leaking: a worn door gasket, a cracked spray arm, or a base-tray leak that trips the safety sensor.
- Will not fill: a failed water inlet valve or a float switch stuck up.
- Error code and stop: a leak sensor, a heater fault, or a control-board issue.
Typical Causes
Drainage complaints top the list. The filter at the bottom of the tub traps food and grease, and when it is not rinsed periodically the water cannot clear, which looks like a pump failure but often is not. When the filter is clean, the drain pump or a kinked drain hose is next. Leaks on many Bosch, Thermador, and other European-built models are handled by a base-tray sensor that shuts the unit down and shows a code the moment water reaches the pan, protecting your floor but stopping the cycle until the source is found. We trace the leak to the gasket, spray arm, or hose rather than just clearing the code.
Brands We Service
We repair dishwashers from Cove, Bosch, Miele, Thermador, Gaggenau, KitchenAid, Jenn-Air, and Monogram. Cove and Bosch panel-ready units are among the ones we see most.
Fault Reference
| Symptom | Likely Cause | What We Do |
|---|---|---|
| Will not drain | Filter, hose, or pump | Clear the path, test and replace the pump |
| Dishes wet | Rinse aid or element | Check drying system, replace the element |
| Leaking | Gasket or base tray | Find the source, replace the gasket or hose |
| Will not fill | Inlet valve or float | Test and replace the valve or free the float |
| Error code | Leak or heater fault | Read the code and repair the underlying part |
Dishwasher Leaking or Stuck?
Book a visit and get a written estimate first. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.